Use and Care Manual

Model G1014Z/G1014ZX (Mfd. Since 07/17)
-19 -
G1014Z Stand
Assembly
The Model G1014Z stand can be assembled with
the included feet or mounted directly to a concrete
floor (refer to Mounting to Shop Floor on Page
18 for further details).
To assemble the G1014Z Stand:
1. Insert a
5
⁄16"-18 x 1" hex bolt through bottom
of rubber foot, then insert foot into bottom of
leg and fasten it finger tight with
5
⁄16"-18 hex
nut and flat washer, as shown in Figure 13.
2. Repeat Step 1 to install remaining feet on the
other three legs.
Figure 13. Foot fastened to bottom of a leg.
Rubber Foot
LEG
Hex Bolt
Hex Nut
3. Fasten a long upper and long lower brace
to the two stand legs with (8)
5
⁄16"-18 x
1
⁄2"
carriage bolts,
5
⁄16"-18 hex nuts, and
5
⁄16" flat
washers, as shown in Figure 14. Finger
tighten the fasteners for now.
Note: Make sure the lip on the long braces
faces up.
Figure 14. Stand legs fastened to long braces.
Leg
Long Lower Brace
Long Upper Brace
x 8
Lip
4. Repeat Step 3 to fasten the two remaining
long upper and long lower braces to the
remaining stand legs.