Use and Care Manual

-16-
Model G1014Z/G1014ZX (Mfd. Since 07/17)
G1014ZX Inventory
Box 1 (Figures 7–8) Qty
A. Sander Unit ................................................. 1
B. Sanding Belt 6" x 48" .................................. 1
C. Dust Port 2
1
⁄2" (Black) .................................. 1
D. Work Table .................................................. 1
E. Miter Gauge ................................................. 1
F. Back Stop .................................................... 1
G. Rubber Feet (Cabinet) .................................4
H. Quick Release Lever Handle ...................... 1
I. Table Support Rod ...................................... 1
J. Quick Release Lever Stud........................... 1
K. Short Lever, 4
1
⁄2" Long ................................. 1
L. Idler Roller Guard ........................................ 1
M. Idler Roller ................................................... 1
N. Cast Iron Plate ............................................. 1
O. Sanding Disc 9" ........................................... 1
P. Dust Port 2" (Green) .................................... 1
Hardware & Tools (not shown) Qty
• Hex Wrench 4mm ........................................ 1
• Hex Bolts
5
⁄16"-18 x
1
⁄2" (Sander & Cabinet) . 4
• Flat Washers
5
⁄16" (Sander & Cabinet) ......... 4
• Phillip Head Screws #10-24 x
1
⁄2"
(2
1
⁄2" Dust Port) ............................................ 4
• Hex Nuts #10-24 (2
1
⁄2" Dust Port) ................ 4
• Flat Washers #10 (2
1
⁄2" Dust Port) ............... 4
• Hex Nuts
3
⁄8"-16 (Quick Release Lever) ...... 2
Box 2 (Figure 9) Qty
Q. Cabinet ........................................................ 1
R. Shelf ............................................................ 1
Hardware (not shown) Qty
• Hex Nuts 5/16"-18 (Cabinet) ........................ 4
• Hex Bolts
5
⁄16"-18 x 1" (Cabinet) ................... 4
• Flat Washers
5
⁄16" (Cabinet) ......................... 4
Figure 7. G1014ZX sander unit.
A
Figure 9. Cabinet inventory.
R
Q
Figure 8. G1014ZX loose inventory items.
O
C
D
E
G
H
J
B
K
P
I
F
M
L
N
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.