Use and Care Manual

Model G1014Z/G1014ZX (Mfd. Since 07/17)
-15-
G1014Z Inventory
Box 1 (Figures 4–6) Qty
A. Sander Unit ................................................. 1
B. Stand Legs .................................................. 4
C. Long Lower Braces ..................................... 2
D. Long Upper Braces ..................................... 2
E. Short Lower Braces ..................................... 2
F. Short Upper Braces ..................................... 2
G. Sanding Belt 6" x 48" .................................. 1
H. Dust Port 2
1
⁄2" (Black) .................................. 1
I. Work Table .................................................. 1
J. Miter Gauge ................................................. 1
K. Back Stop .................................................... 1
L. Rubber Feet ................................................ 4
M. Table Support Rod ...................................... 1
N. Quick Release Lever Stud........................... 1
O. Short Lever, 4
1
⁄2" Long ................................. 1
P. Quick Release Lever Handle ...................... 1
Q. Idler Roller ................................................... 1
R. Idler Roller Guard ........................................ 1
S. Dust Port 2" (Green) .................................... 1
T. Cast Iron Plate ............................................. 1
U. Sanding Disc 9" ........................................... 1
Hardware & Tools (not shown) Qty
• Hex Wrench 4mm ........................................ 1
• Hex Bolts
5
⁄16"-18 x 1" (Feet) ........................ 4
• Hex Nuts
5
⁄16"-18 (Feet, Stand) .................. 36
• Flat Washers
5
⁄16" (Feet, Stand) ................. 40
• Hex Bolts
5
⁄16"-18 x
1
⁄2" (Stand & Sander) .... 4
• Carriage Bolts
5
⁄16"-18 x
1
⁄2" (Stand) ........... 32
• Phillip Head Screws #10-24 x
3
⁄8"
(2
1
⁄2" Dust Port) ............................................ 4
• Hex Nuts #10-24 (2
1
⁄2" Dust Port) ................ 4
• Flat Washers #10 (2
1
⁄2" Dust Port) ............... 4
• Hex Nuts
3
⁄8"-16 (Quick Release Lever) ...... 2
Figure 4. G1014Z sander unit.
A
Figure 5. G1014Z stand components.
B
C
D
E
F
Figure 6. Loose inventory items.
V
H
I
J
K
L
M
O
G
N
U
P
Q
R
S
T
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.