Owners manual

INSTALLATION
INSTRUCTIONS
REMOVAL
WORLDWIDE, LLC
Lay the chain on the ground
with the yellow plastic end of
the cable towards the left.
From the left to the right, pass
the flexible cable (yellow plastic
end first) behind the tire.
Take both ends of the inside
flexible cable and fasten them
on top of the tire.
Hook the outside flat green
connector to the last link of
the yellow chain end.
Push the inside cable towards the interior of the wheel. Make
sure it is behind the wheel, not on the tire tread.
Pass the red chain into the
red self-locking slide gear.
Thread the elastic tensioner
into the red metal ring. Pull
on the tensioner as much as
possible and fasten the end
into a link of the side chain.
Stop the vehicle so that the
outside flat green hook is at
the top of the tire.
Unhook the elastic tensioner
and pass the tensioning chain
first through the red ring,
then out of the red slide gear.
Unfasten the inside cable and
allow the chain to fall on the
ground. Move the vehicle until
the tire does not stand on the
chain any longer.
© 2014 RLB Worldwide LLC
1 2 3
4
5a 5b 6
7
1 2
3