User Manual

To connect your Grizzl-E Smart to Wi-Fi:
1. Plug in the Charger.
2. Open the Wi-Fi settings on your computer or cell phone.
3. Select the network UC_Smart_[ChargerSerial#]*.
4. Open your browser.
5. Enter the IP address 192.168.4.1 into the browser search bar.
6. A webpage will load. Select the Enter Router Credentials button.
7. Enter the SSID** and Password for your Wi-Fi network. Leave
acharger.ca in the Portal URL.
8. Verify that you are connected. If connection is successful the
indicator light will alternate between Blue and Light Blue.
9. Disconnect your smartphone from UC_Smart_#### and re-
connect to your local network.
10. Close the browser page.
Connect Charger To Wi-Fi Network
*Note: Your device may state that the Wi-Fi network is not connected to the internet. Continue without Internet until the end of the procedure.
**SSID is the network name.