User Manual
Table Of Contents
- 1. Introduction and Unpacking
- 2. Installation Planning and Service Wiring
- 3. Maximum Current Output
- 4. Mounting Bracket
- 5. EasyEvPlug Holster and Cable Management System
- 6. Charging Status Indicators and Buzzers
- 7. Grizzl-E Mini Smart Features
- 8. Operation
- 9. General Product Care and Use
- 10. Warranty and Return Policy
20
7.2 Status
Select the Status Icon in the top Menu:
Condition
Term Denition
Status Displays the real-time status of the charger.
Plugged In Displays if the charger is plugged into the vehicle.
Voltage The measured voltage from the charger.
Current The measured current being delivered to the vehicle.
Power, kW The measured power delivered to the vehicle in kW.
Relay Temperature °C The measured temperature of the charger’s interior.
Session, kWh The total kWh delivered to the vehicle since the start of the
charging session. The charging session begins when charging is
initiated and ends upon removing the plug from the vehicle.
Session Time Total time of the charging session. The charging session begins
when charging is initiated and ends upon removing the plug
from the vehicle.
Session cost
The charging session cost equals the Session, kWh x the active
Rate. For information on setting the rate, see “Rates” on page
24 setting.
Rate
Displays the active rate used to calculate the Session Cost.
For information on setting the rate, see “Rates” on page 24
setting.
Total kWh The total power delivered by the charger over its life.