User Manual
Table Of Contents
- 1. Introduction and Unpacking
- 2. Installation Planning and Service Wiring
- 3. Maximum Current Output
- 4. Mounting Bracket
- 5. EasyEvPlug Holster and Cable Management System
- 6. Charging Status Indicators and Buzzers
- 7. Grizzl-E Mini Smart Features
- 8. Operation
- 9. General Product Care and Use
- 10. Warranty and Return Policy
14
4. Mounting Bracket
Before mounting, determine the location of an acceptable mounting support. All charging
station products must be anchored into a mounting support such as a 2” x 4” stud or a solid
concrete wall. DO NOT mount this unit directly to a stucco/drywall/wallboard.
1. Secure the back piece of the mounting bracket to the wall or other suitable structure using
the Mounting screws.
Mount the unit at least 18in (460mm) above floor level. The charging station should be less
than 24in (610mm) from the NEMA 14-50 outlet. The NEMA 14-50 outlet should be located in
compliance with all applicable local electrical safety codes and standards.
2. Side the Mini Grizzl-E down into the mounting bracket. Slide the Grizzl-E Mini up out of the
mounting bracket for a portable charger.