Technical Specifications

1110
OPERATIONOPERATION
LOADING FASTENERS
LOADING INSTRUCTIONS
A fastener can be driven unintentionally if the trigger and safety bracket
are activated at the same time. Always disconnect tool from air supply
before loading fasteners, making adjustments, or performing any service
on tool. Keep finger off trigger until ready to drive a fastener.
DANGER
1. Pull pusher (A) back to latched
position at rear of magazine.
2. Load staple strips (B) over
magazine track. Slide strips
down so that staple crowns
ride on top rail, then slide
forward toward tool nose.
3. Pull pusher (A) back and press
release lever (C) to release
latch. Slide pusher forward
against staple strips and
release. DO NOT allow pusher
to snap forward against
staples.
4. Tool is now loaded and ready
to be connected to an air
supply for operation.
5. Reload when indicator triangles
on magazine (D) and pusher
(E) are aligned.
A
C
B
ADJUSTING STAPLE DRIVE
1. Disconnect tool from air supply
using quick-connect coupling.
2. Loosen adjustment screw, and
move tip of lower safety
element up to increase fastener
drive, or move down to de-
crease drive. Tighten screw
securely.
3. Connect tool to air supply, and
drive staples to check for
correct depth of drive.
4. Make depth of drive adjust-
ments as needed to maintain
consistent staple driving.
CLEARING STAPLE JAMS
1. Disconnect tool from air supply
using quick-connect coupling.
2. Pull pusher back to latched
position at rear of magazine.
3. Open E-Z Clear latch and open
door.
4. Remove jammed fastener.
5. Close door and secure with
latch.
6. Release pusher and slide
forward against staple strips.
7. Connect air supply and check
tool for normal operation.
STAPLE TOO
HIGH
MOVE TIP UP
STAPLE TOO
DEEP
MOVE TIP
DOWN
Drive
Deeper
Drive
Shallower
MOVE
TIP UP
MOVE
TIP
DOWN
E
D