User's Manual

The freezer is equipped with an automatic defrost system to allow the frozen product to melt back to a liquid. This
eliminates any large ice crystal formation or poor product consistency that may develop. This automatic timer can be
pre-programmed to occur at desired times of the day. The defrost cycle takes four hours to complete and should be
programmed in.
The freezer has been operated and tested at the factory. Upon arrival the complete freezer
must be thoroughly checked for any damage which may have occurred in transit. NOTE: A
Tip (N) Tell warning device is placed on each shipping carton at the factory. If the arrow tip is
blue, the carton has been tipped in transit. (See Figure 1)
IMPORTANT: The carrier is responsible for all damage in transit whether visible or con-
cealed. DO NOT PAY THE FREIGHT BILL until the freezer has been checked for damage.
Have the carrier note any visible damage on the freight bill. If concealed damage and/or
shortage is found later, advise the carrier within 10 days and request inspection. The cus-
tomer must place any claim for damage and/or shortage with the carrier. The manufacturer
cannot make any claims against the carrier.
1) Read and understand the operating instructions in this manual thoroughly.
2) Note all warning labels on the freezer.
3) Do not wear loose fitting garments or jewelry that could cause a serious accident.
4) Stay alert at all times during operation.
5) Keep operating area clean.
Do not operate freezer if any excessive noise or vibration occurs. Contact an authorized service agent.
Safety and Inspection
Safety Precautions
Loose Parts Shipped with Unit
Unpacking and Inspection
Shipment and Transit
Figure 1
Crathco Beverage Freezers
Page 3
Part # Name Quantity
90881 Installation Guide 1
90882 Operators Manual 1
W0660060 Plastic parts bag 1
W0600121 Header installation instruction sheet 1
W0631903 Sanitizer packets 6
W0600159 Warranty card 1
W0890237 Drip pan kit 1
W0340022 “O” ring #213 6
W0660300 Dow Corning Silicone lubricant 1
W0480437 Plunger, Slush pressure 1
W0480445 Handle, valve 1
W0611728 Fas-Pin 1
W0631230 Compression Spring 1
W0660016 Silicone adhesive 1
W0610718 Screw 5/16-18 Hex Hd 2
W0611255 Washer, 5/16” lock 2
W0611086 Nut, 5/16” Hex, Zinc 2
60382 Heyco 1” snap bushing 1
90748 Silicone Nozzle 6
90749 Bottle Holddown Clamp 6
90750 Adjustment Knob 6
90770 90° Support 1
90878 Lock Washer #10 6
W0611254 Washer 2
W0631549 Coke® Cleaning Fitting 1