Owner manual

Procedure:
1. Begin by collecting your tools and popping your hood. This’ll be quick!
2. Now, remove your driver’s side triangulation bar nuts using a 12mm wrench.
You’ll remove two (2) nuts on the driver’s side strut tower. Set these aside,
you’ll need them again in just a minute. Repeat on passenger side.
Figure 2: Remove 12mm nuts on each side
3. Next, simply place your GrimmSpeed strut tower brace into place. It may
help to know that the logo is on the passenger side, but the brace will only fit
on one way.
Figure 3: Place brace
Place Strut Brace
Remove 12mm nuts