Manual
page 16
page 17
Take a speaker cabinet and lay it down on the empty and closed shipping
crate or on a big, clean table, with the drivers facing up. Place two of the
legs next to it, one with and one without electronics.
Normally, when setting up in a living room, you´ll prefer the electronics
panel facing to the back side of the speaker in order to look uncluttered. In
this case put the ’active leg‘ on the left side, next to the speaker cabinet on
the table, the other leg to the right side. If for some reason you want the
electronics to face the front side of the speakers, you can simply swap the
legs.
The multipin connector that is used to connect the speaker cabinet to
the electronics contained in the leg can be pulled out of either side of the
bottom aluminium prole attached to the cabinet. So the choice is yours,
where to place the ’active leg‘.
Plug the cable connector into the chassis connector of the leg.
Very Important:
Every speaker is individually measured and tuned during manufacturing,
the unique correction curve for this speaker is then stored in the DSP of the
matching electronics.
Therefore both parts, speaker and electronics, get the same serial number.
Please always make sure you assemble the matching electronics with its
proper speaker.
Unpacking and Assembly
Unpacking And Assembly
Unpacking And Assembly