Manual

page 62
page 63
Connectivity
Connectivity
Connectivity
In case you do not use a pc or media player with 'USB DAC output' for music playback, you may
remove the LS1i USB interface from your system after the initial setup. The connections are as
pictured on the left page. As you can see, the LS1r Controller is now directly connected to the
rst LS1. Whenever you feel need to make adjustments to the LS1 preference settings, just
connect the LS1i USB interface again. The input options in this case are as follows:
1. Analog input on the left and right LS1
-> Here both speakers must be connected to the respective left or right line level output from your analog
source. If no LS1r or LS1i is connected and there is no digital source present, the LS1 defaults to the analog
input.
2. Digital input on the main LS1
-> In case your source has a digital S/PDIF (RCA-connector) out instead of an AES/EBU (XLR-connector)
out, please use the supplied adapter cable, which takes care of the impedance matching inbetween those!
3. Digital inputs on the LS1r Controller
The LS1r Controller has two additional digital inputs. This keeps cable connections short and tidy,
as the remote can be put right next to the source.