Manual

page 54

page 55

Software Control Settings

The last tab: System.

System - Here you can see if the communication path between all parts of the chain (LS1r

Controller, software remote, and LS1's) is properly working. In case you nd an error message,

please check the wiring and whether you have inserted the little cat5 ’loop back‘ plug in the last

LS1's ’Thru‘ connector.

If everything is running ne, there‘s an indication of the amount of LS1's detected in the chain.

LS1 internal memory - By clicking the button ’Restore speaker settings to default‘ you bring all

settings of the LS1 back to the factory default state.

Firmware - In this eld the rmware version of the connected LS1's is indicated and you can

compare it to the rmware version that is shipped with the LS1 remote software. If you see the

software has a newer rmware version then your LS1's, you are advised to perform a rmware

update. Please rst select a speaker in the right-hand menu and then press the ’Do rmware

update‘ button. This will start the update procedure for the selected speaker. The process takes

some time, please allow it to nish completely before touching anything. Once the upload is

nished the speaker will reboot and when it‘s up again, the software shows that the rmware is

up to date.

Warning! Before starting a rmware update, please take care of the following precautions:

1. Stop all music playing.

2. Do not touch the LS1r Controller during the rmware update process.

3. You can select one speaker at a time in the interface. Please let the updater nish before

selecting another speaker.

To be completely safe when using the rmware update function, connect just one LS1 at a time

to the USB interface and remove the LS1r Controller. Please make sure the ’loopback connector‘

is in place on the connected speaker, or the update process will not start.

-> if you have any questions about updating the rmware, please make sure to contact your dealer rst.