Manual
page 22
page 23
Unpacking and Assembly
Now you can carefully set the assembled LS1 upright. As mentioned asking
a second person to help you is highly recommended.
Best is to directly place the LS1 close to the right spot in the room. If you
are on your own, the easiest way to carry the speaker is to stand behind it
and grab it underneath the bottom prole of the cabinet with both hands.
With two people the easiest way to carry the LS1 is to stand next to both
sides of the speaker and grab it underneath the bottom cabinet prole
from front and back. This way it is pretty easy to move the speaker to it's
desired location.
If the edges of the cabinet and the leg don't align perfectly you can now
untighten the knurled screw inside the leg just a little bit and align all
edges carefully by hand. The strong magnets provide a secure t of the
legs to the cabinets, while still allowing tiny adjustments in all directions
to make them a perfect t. If you are done aligning the cabinet and legs,
gently tighten the knurled screws. Again there's no need to torque them
down too hard.
The next step is to put the covers on top of the legs, these are only held in
place by magnets and can also be aligned simply by hand.
These steps can now be repeated to assemble the second speaker. In the
next chapter we will have a look at all the connections and peripherals.
If you like to start wiring your system right away, please jump to the
'Connectivity' chapter of this manual.
Unpacking And Assembly
Unpacking And Assembly