LS1be Studio Monitors Manual

page 48
page 49
Software Control Settings
Software Control Settings
Software Control Settings
With the Crossover frequency function you can set the crossover frequency for the 3rd party
subwoofer. If possible, please make sure to set your subwoofer to ’linear‘ and use the crossover
of the LS1 in stead of the lter in the sub. A crossover setting near 70 Hz will usually work well.
The nal parameter is polarity. You may turn the polarity of the subwoofer in phase or out of
phase to optimize the crossover region.
The next page offers the Gain Offsets. All input channels (analog, digital 1, digital 2, digital
3, USB) can get a gain offset to align their level with the other channels. This is convenient in
general but is essential when comparing the sound quality of two sources (’A-B testing‘). To reset
a fader to 0 dB, just double click the fader knob. Mark that the offset is only active when the PC
remote software is running.
Below the gain offset window there‘s a Balance slider to correct for off-center listening or an
acoustical imbalance between left and right. In most cases it is kept at the center position. If you
accidentally moved it, just double click the fader knob to reset it to 0 dB.