Use and Care Manual

Setup
GRILLGRATES
Getting started with
GAS GRILLS
Reduce Flare Ups | Increase surface temperature up to 250°F
1
Prepare Grill:
 Clean grease tra
 Inspect burners and ame tent
 Remove debris from the bottom of the grill.
2
Placement:
 Grates should be on as the grill heats up
 Keep space on the left and right of your grill. This allows heat to escape from beneath the
GrillGrates
 For replacement grates, remove old grates, and replace with correctly tted GrillGrates
 For use of GrillGrates on top of existing grates, place the GrillGrates over the hottest section.
The GrillGrates will slide less as they are used.
charcoal & Kamado GRILLS
Controlled High Heat Grilling | Increase surface temperature up to 250°F
1
Prepare Grill:
Remove debris from the bottom of the grill. This will prevent ames from igniting grease and
debris in the bottom of your grill.
2
Placement:
P lace GrillGrates on top of existing grates when coals are no longer aming and allow to warm
up for ten minutes.
PEL L ET GRILLS
High T emp Sear Station | Increase surface temperature up to 200°F
1
N ote:
P ellet Grill sear stations do not provide full grill coverage in order to allow ample airow. In
testing, we have found that with too many GrillGrate panels, heat can get trapped. W hen this
happens, the fan in the pellet grill turns off, which ultimately turns off the grill.
2
Placement:
Grates should be on as the grill heats up 
If you have a smo k e stac k , place your GrillGrates on the same side and preheat with the grill. If
you don ’ t have a smo k estac k , place in the middle of your grill and preheat with grill. S liding will
reduce over time as the grates become more and more seasoned.