SDS

Material Safety Data Sheet
Report No:ZKS190100188 Page 5 of 9
entering sewers or waterways.
Methods and materials for Containment
Stop the leak if safe to do so. Contain the spilled
liquid with dry sand or earth. Clean up spills
immediately.
Methods and materials for cleaning up
Absorb spilled material with an inert absorbent (dry
sand or earth). Scoop contaminated absorbent into an
acceptable waste container. Collect all contaminated
absorbent and dispose of according to directions in
Section 13. Scrub the area with detergent and water;
collect all contaminated wash water for proper
disposal.
Section 7 – Handling and Storage
Handling
Do not dismantle, open or shred secondary Lithium
Polymer Battery;
Don’t handling Lithium Polymer Battery with
metalwork. Do not open, dissemble, crush or burn
battery. Ensure good ventilation/ exhaustion at the
workplace.
Prevent formation of dust.
Information about protection against explosions and
fires: Keep ignition sources away- Do not smoke.
Storage
If the Lithium Polymer Battery is subject to storage
for such a long term as more than 3 months, it is
recommended to recharge the Lithium Polymer
Battery periodically.
3 months: -10℃~+40℃, 45 to 85%RH
And recommended at 0℃~+35℃ for long period
storage.
The capacity recovery rate in the delivery state
(50% capacity of fully charged) after storage is
assumed to be 80% or more.
Do not storage Lithium Polymer Battery
haphazardly in a box or drawer where they may
short-circuit each other or be short-circuited by other
metal objects.
Keep out of reach of children.
Do not expose Lithium Polymer Battery to heat or
fire. Avoid storage in direct sunlight.
Do not store together with oxidizing and acidic
materials.