Safety data sheet

Page 4/9
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 13.08.2016 Revision: 13.08.2016Version number 85
Trade name: Griffon Verimor
(Contd. of page 3)
43.0
.
Information about fire - and explosion protection:
Do not spray onto a naked flame or any incandescent material.
Keep ignition sources away - Do not smoke.
Pressurised container: protect from sunlight and do not expose to temperatures
exceeding 50 °C, i.e. electric lights. Do not pierce or burn, even after use.
.
7.2 Conditions for safe storage, including any incompatibilities
.
Storage:
.
Requirements to be met by storerooms and receptacles:
Observe official regulations on storing packagings with pressurised containers.
.
Information about storage in one common storage facility:
Not required.
.
Further information about storage conditions:
Keep receptacle tightly sealed.
.
7.3 Specific end use(s)
No further relevant information available.
8 Exposure controls/personal protection
.
Additional information about design of technical facilities:
No further data; see item 7.
.
8.1 Control parameters
.
Ingredients with limit values that require monitoring at the workplace:
91-20-3 naphthalene
IOELV (European Union) Long-term value: 30 mg/m³, 10 ppm
.
Additional information:
The lists valid during the making were used as basis.
.
8.2 Exposure controls
.
Personal protective equipment:
.
General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
Avoid contact with the eyes.
Avoid contact with the eyes and skin.
.
Respiratory protection:
Not required.
.
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the
substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the
product/ the preparation/ the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates
of diffusion and the degradation
.
Material of gloves
The selection of the suitable gloves does not only depend on the material, but
also on further marks of quality and varies from manufacturer to manufacturer. As
the product is a preparation of several substances, the resistance of the glove
material can not be calculated in advance and has therefore to be checked prior
to the application.
(Contd. on page 5)
GB-EN
GRIFFON VERIMOR AER 300ML*12 L1
1235602 - GRIFFON VERIMOR AER 300ML*12 L1
www.griffon.eu 4/9