Safety data sheet

ManualsBrandsGRIFFON ManualsAdhesivesUNI-100 XT Glue 125 ml

Page 4/8

Safety data sheet

according to 1907/2006/EC, Article 31

Printing date 30.04.2015 Revision: 30.04.2015Version number 11

Trade name: Griffon Uni 100 XT

(Contd. of page 3)

40.1.5

8.1 Control parameters

Ingredients with limit values that require monitoring at the workplace:

78-93-3 methyl ethyl ketone

WEL Short-term value: 899 mg/m³, 300 ppm

Long-term value: 600 mg/m³, 200 ppm

Sk, BMGV

Ingredients with biological limit values:

78-93-3 methyl ethyl ketone

BMGV 70 µmol/L

Medium: urine

Sampling time: post shift

Parameter: butan-2-one

Additional information:

The lists valid during the making were used as basis.

8.2 Exposure controls

Personal protective equipment:

General protective and hygienic measures:

The usual precautionary measures are to be adhered to when handling chemicals.

Keep away from foodstuffs, beverages and feed.

Immediately remove all soiled and contaminated clothing

Wash hands before breaks and at the end of work.

Avoid contact with the eyes.

Avoid contact with the eyes and skin.

Respiratory protection:

In case of brief exposure or low pollution use respiratory filter device. In case

of intensive or longer exposure use self-contained respiratory protective device.

Protection of hands:

Solvent resistant gloves

The glove material has to be impermeable and resistant to the product/ the

substance/ the preparation.

Due to missing tests no recommendation to the glove material can be given for the

product/ the preparation/ the chemical mixture.

Selection of the glove material on consideration of the penetration times, rates

of diffusion and the degradation

Material of gloves

The selection of the suitable gloves does not only depend on the material, but

also on further marks of quality and varies from manufacturer to manufacturer. As

the product is a preparation of several substances, the resistance of the glove

material can not be calculated in advance and has therefore to be checked prior

to the application.

Penetration time of glove material

The exact break trough time has to be found out by the manufacturer of the

protective gloves and has to be observed.

For the permanent contact of a maximum of 15 minutes gloves made of the following

materials are suitable:

PVC or PE gloves

Eye protection:

Tightly sealed goggles

Body protection:

Solvent resistant protective clothing

(Contd. on page 5)

DPD Declaration

GRIFFON UNI-100 XT FBX 125ML*30 L1

6300545 - GRIFFON UNI-100 XT FBX 125ML*30 L1