MANUAL
Thank you for purchasing the iTrip, the only wireless FM transmitter made specifically for the iPod. Now you can play your music in your car or anywhere there's an FM radio. We'll have you up and running in three easy steps. iTRIP QUICK START (Mac) 1 Insert the included iTrip CD-Rom into your Mac. Launch and run the iTrip Installer. All necessary files are now installed into iTunes. 2 Connect and sync your iPod with iTunes.
iTRIP QUICK START (PC) 1 Insert the included iTrip CD-Rom into your PC. The iTrip Installer should begin automatically. If this does not happen, simply run the Setup.EXE file located on the iTrip CD-Rom. This will install all necessary files into MusicMatch or iTunes. 2 Connect and sync your iPod with MusicMatch or iTunes. This will transfer the newly created iTrip Stations playlist and files into your iPod.
The iTrip can broadcast to any spot on your FM radio. Scan the FM stations to find an empty frequency. Then follow these simple steps to set your iTrip to broadcast to that selected frequency. PLAY/PAUSE ( ) button CHOOSING A NEW BROADCAST FREQUENCY 1 Navigate to the iTrip Stations playlist installed on your iPod. 2 Highlight the chosen frequency and click the PLAY/PAUSE ( ) button. ) button 3 When the LED begins to rapidly blink, click the PLAY/PAUSE ( once again.
TURNING THE LED ‘OFF’ OR ‘ON’ To turn the status LED on the front of the iTrip OFF, navigate to the bottom of the iTrip Stations playlist and select “LED off”. Then follow these two simple steps. 1 Click the PLAY/PAUSE ( ) button on your iPod. 2 When the LED begins to rapidly blink, click the PLAY/PAUSE ( again. The LED will pulse three times slowly to confirm. ) button The LED will remain off until you change frequencies.
iTRIP TROUBLESHOOTING The iTrip won’t wake up from sleep. The iTrip automatically wakes from sleep when music is played into it. The first thing to check is that you're playing sufficiently loud music into your iTrip. When the iTrip begins to wake from sleep, it can take several seconds, depending on its set frequency. The higher the frequency, the longer the iTrip takes. So if you have iTrip tuned to 107.9 it may take a while. But be patient - it will come on.
iTRIP TECHNICAL SPECIFICATIONS • Dimensions: 2.4" x .84" • Built-in antenna • Power Requirement: iPod connection • Modulation: FM Stereo • Frequencies: 87.9 - 107.9 MHz • High stability crystal oscillator, phase-lock loop control • Stereo separation: greater than 45 dB • Signal distortion: less than .
