Specifications

OEM Integrator Use Conditions
This device is intended only for OEM integrator use under the following conditions. The module can be used as
certified in a host product if:
1. The internal PCB antenna or external antenna (only those listed below with a unique antenna connector) for
the GC-ESP32-ETH are installed such that 20 cm is maintained between the antenna and any end user (mobile
use).
2. The antenna(s) used with this transmitter do not transmit simultaneously with any other antenna or transmitter,
except in accordance with FCC multi-transmitter product procedures. The integrator is fully responsible for proper
evaluation (i.e. C2PC or new certification as appropriate) of any co-location as required by FCC and ISED
regulations.
3. The module is used with only the antenna(s) tested and certified with this module as listed below.
4. The OEM integrator confirms ongoing compliance of the integrated module in line with 996369 D04 Module
Integration Guide v02. Please contact GridConnect on how to configure test modes for host product evaluation.
In the event that the above conditions cannot be met (for example device configuration or co-location with another
transmitters), then the FCC / ISED authorization for this module in combination with the host equipment is no
longer considered valid and the FCC ID / IC number of the module cannot be used on the final product. In these
and circumstance, the OEM integrator will be responsible for a new certification.
This module is designed and certified under FCC Rules CFR 47 Part 15.247 and ISED Canada regulation RSS-
247.
OEM Integrator Labeling and Instructions to the End User
The final host product must be labeled in a visible area with the following:
Contains FCC ID: 2AFC3ESPSM001, IC: 22503-ESPSM001
The final (Host) product or its manual must include instructions to the end user as follows:
Radiation Exposure Statement: This equipment complies with FCC and ISED radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
Note: Changes or modifications not expressively approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux
rayonnements ISED établies pour un environnement non contrôlé. Cet équipement doitêtre installé et utilisé
avec un minimum de 20cm de distance entre la source de rayonnement et votre corps.
Please contact Grid Connect for details on how to configure FCC test modes for host product evaluation. The
host product manufacturer is responsible for compliance to any other FCC rules applicable to the host product
(e.g. the host product may still require Part 15 Subpart B compliance testing with the modular transmitter
installed). Please see FCC 996369 D04 Module Integration Guide for further guidance.