Cov lus qhia

Connect Grizzl-E Smart to ChargeLab

Note: Ensure Firmware Version 5.53 or later is installed on Grizzl-E Smart before

connecting to ChargeLab.

1. Plug in the Charger. Ensure indicator light is

alternating Blue and Purple. Ensure the unit

is disconnected from the network.

2. Open the Wi-Fi settings on your smartphone

or desktop.

3. Select the network UC_Smart_

[ChargerSerial#]. Find the Charger Serial

Number on the white label on the side of the

Grizzl-E Smart.

4. Open the browser on your phone or desktop.

5. Enter the IP address 192.168.4.1 into the

browser search bar. A webpage will load.

6. Select the Show Available Networks button.

7. Find your Wi-Fi Network on the list of

available networks. Ensure you can see the

network and that Rssi is between -50 and -79.

8. Select the Wi-Fi network from the list of

available networks. This should highlight the

network.

PAGE 1
Connect Grizzl-E Smart to ChargeLab Note: Ensure Firmware Version 5.53 or later is installed on Grizzl-E Smart before connecting to ChargeLab. 1. Plug in the Charger. Ensure indicator light is alternating Blue and Purple. Ensure the unit is disconnected from the network. 2. Open the Wi-Fi settings on your smartphone or desktop. 3. Select the network UC_Smart_ [ChargerSerial#]. Find the Charger Serial Number on the white label on the side of the Grizzl-E Smart. 4.
PAGE 2
9. Close the Available Networks box and select the Enter Credentials button. The network you selected should be pre-populated in the SSID field. 10. Type the Wi-Fi password into the Password field. 11. Select ChargeLab from the List of portal providers. 12. Enable the Public Use checkbox. 13. Select the Enter Credentials button. 14. Wait 30 seconds to verify that your device is connected. If the connection is successful the indicator light will alternate between Blue and Cyan. 15.