Operator's Manual

ETD-100 OPERATOR’S MANUAL
24
has been removed and the User has pressed CONTINUE, the device will run an extended flush followed by a sample
test to ensure that the next sample will not be contaminated.
The figures below illustrate the screens that will be seen following a swab testing.
6.3.2.1 PASS Screen
The PASS Screen will be displayed after a swab has been tested and cleared of inorganic material.
A “PLEASE WAIT…” prompt will be displayed for a few seconds after testing is complete. The Graph Button
will show the User the Electropherogram for the previously run sample test. Once on the Electropherogram
page, the User can use the back button to return to the PASS Screen. Once the CONTINUE button is
displayed, it can be used to return the User to the INSERT SWAB Screen.
Figure 20: PASS, WARNING and OVERLOAD Screens (CONTINUE)
Figure 21: PASS Screen and Electropherogram Results