Operator's Manual

ETD-100 OPERATOR’S MANUAL
18
5. After login an INITIALISING Screen displays until the device is ready to operate (normally in 10-15 minutes).
6. The Settings button can be pressed during the initialising process to review stored files. Refer to Section 6.2.2
The Settings Screen.
Figure 9: Initialising Screen
7. If the User enters an incorrect PIN, the 6 circles on the left of the PIN code Screen will turn red indicating
incorrect PIN entry.
8. Following three failed login attempts, the User will be locked out of the device for 1 minute or until a
Supervisor unlocks the User account.
Figure 10: Incorrect PIN code Entry and Lock Out Screen
9. Once the device is finished calibrating, INSERT SWAB indicates the device is ready for a test sample.
NOTE: WHEN THE DEVICE IS POWERED UP IT WILL BEGIN INTIALISING(CALIBRATING).
THE DEVICE MAY HAVE COMPLETED THE CALIBRATION PROCESS WHILE THE USER IS
COMPLETING THE LOGIN PROCESS.
NOTE: FOLLOWING THREE FAILED LOGIN ATTEMPTS, THE USER WILL BE LOCKED OUT
OF THE DEVICE FOR 1 MINUTE