Operator's Manual

ETD-100 OPERATOR’S MANUAL

6 Everyday Use - Operator

6.1 Startup and User Login

To log in to the device:

1. Make sure the device power cable is plugged in, via the adaptor into a wall power outlet that is switched on.

2. Turn the device on by depressing the Power Button. The LED will illuminate red to indicate the device is on.

3. Once the device has powered up, the GreyScan logo splash Screen will be displayed, followed by the PIN

code Screen. The PIN code Screen may take up to 30 seconds to load.

Figure 7: Device splash Screen

4. Enter the relevant Operator or Admin/Lab User PIN code using the touch Screen digits as illustrated in Figure

8. The circles on the bottom left of the Screen will turn blue as digits are entered.

Figure 8: PIN Code Screen

NOTE: NOT ALL DEVICE SOFTWARE FUNCTIONS WILL BE AVAILABLE TO ALL USERS.

ACCESS LEVELS DIFFER DEPENDING ON PERMISSIONS ASSIGNED TO USER LOGINS.

NOTE: A DEFAULT PIN CODE WILL BE PROVIDED DURING ETD-100 OPERATOR TRAINING

AND IS ALSO PROVIDED IN THE QUICK START GUIDE.