User's Manual

Step 3. Wearing the everbeat watch

Note: Click on this LINK to watch a video showing how to put on the everbeat watch.

Fitting the watch for good contact is very important to ensure a good ECG reading.

Note: A successful recording may be difficult with very dry skin. If you experience such difficulty,

try moistening your skin.

1.Strap your everbeat on your wrist with the metal contact close to your

body on your thumb side

2. Thread the button side of the band through the loop side of the band.

3. Pull the button side of the band towards you, holding the loop side tight to you

4. Using your pointer finger between your wrist and the band, squeeze between

your thumb and finger to snap the band on securely.

CAUTION: The everbeat watch is not designed for wet or humid environments. You should remove your

watch when showering, bathing, swimming – or any under circumstances where the watch might get wet.

Step 4. Connecting your everbeat watch to the everbeat App

1. Open your everbeat app on your iPhone

2. Touch the menu icon on the top left corner of the screen. Pick the CONNECT option.

3. Select your Everbeat Watch from the AVAILABLE WATCHES section – It will then

display under the CONNECTED WATCH section.

4. Turn your iPhone’s Bluetooth off & on again if you cannot find your watch.

5. If you put the watch on your right wrist click that button on the Watch Settings menu.

Once you have completed these steps you are connected to your everbeat watch. If your watch

and phone are out of Bluetooth range of each other, they will disconnect. They will automatically

reconnect when they are within range (about 30 feet).