User manual

ManualsBrandsGREISINGER ManualsEnvironmental Testing EquipmentGHM GMSD-2,5MR-K31

H32.0.0X.6C-06 Operating Manual GMSD … - K31 page 2 of 4

Content

1 INTENDED USE ...................................................................................................................................................... 2

2 GENERAL ............................................................................................................................................................... 2

3 DISPOSAL .............................................................................................................................................................. 2

4 OPERATING AND MAINTENANCE ADVICE ........................................................................................................ 3

5 SAFETY REQUIREMENTS: ................................................................................................................................... 3

6 SPECIFICATION: GMSD … .. - K31 ..................................................................................................................... 4

6.1 SPECIFICATION (GMSD … BA - K31): ................................................................................................................ 4

6.2 SPECIFICATION (GMSD … ..R - K31): ................................................................................................................. 4

6.3 COMMON SPECIFICATIONS (GMSD … BA - K31, GMSD … ..R - K31): ................................................................ 4

1 Intended use

The pressure sensors are designed for the connection to an hand-held instrument of the following types:

GMSD 3111, GMSD 3151 and GMSD 3156 as well as GMSD 3110, GMSD 3150 and GMSD 3155

And to the universally pressure measurement system:

GDUSB 1000

The sensors in plastic housing are designed for following application areas:

• air

• non-corrosive, non-ionising gases

Tube connection:

Be careful when mounting tubes to the pressure ports!

Only press tubes on port in straight direction – avoid side forces to the ports, because these may break the port.

Only use plastic tubes with inner diameter of 4 mm, e.g. 6/4 (Ø 6 mm outside / Ø 4 mm inside).

2 General

Read through this document attentively and make yourself familiar to the of the device before you use it.

Keep this document in a ready-to-hand way in order to be able to look up in the case of doubt.

3 Disposal

This device must not be disposed as “residual waste”.

To dispose this device, please send it directly to us (adequately stamped).

We will dispose it appropriately and environmentally friendly