Instructions
H82.0.03.6C-08 Operating Manual GMH 5155 page 14 of 22
_____________________________________________________ _____________________________________________________________________________
8 Data Logger
The device supports two different logger functions:
“Func-Stor”:
Additional input of measuring point (L-Id) is needed
“Func-CYCL”: Automatic recording at intervals of set cycle time
The logger stores 9 measuring values per data set:
measuring or average (depends on function), min-peak and max-peak sensor 1
measuring or average (depends on function), min-peak and max-peak sensor 2
measuring or average (depends on function), -min-peak and max-peak sensor 1 sensor 2
- *): Calculated value and dummy value
Min- and max-peak are the minimum and the maximum of the measured values since the last recording.
This allows precise analysis of the current pressure as well as pressure fluctuations.
For the evaluation of the data the software GSOFT3050 (version V3.0 or higher) has to be used. The
software also allows easy configuration and starting of the logger.
When the logger is activated (Func Stor or Func CYCL) the hold function is no more available, the key
operation of the logger functions.
8.1 Manual Recording (“Func-Stor”)
a) Save measurements manually:
(p.r.t. :
Press “store” shortly:
where XX is the number of the data set)
Input of measuring point - or .
Number 0 19999 or text assigned to number 1 40 (comfortable assignment of texts can be
done with gratis software GMHKonfig)
Confirm input with .
One data set contains:
- Sensor 1: measuring value at the time of the recording
- Sensor 1: min-peak, max-peak since the last recording
- Sensor 2: measuring value at the time of the recording
- Sensor 2: min-peak, max-peak since the last recording
- Difference sensor 1-sensor 2: measuring value at the time of the recording
- CALC off *) Difference sensor 1-sensor 2: min-peak, max-peak since the last recording
CALC active *) Calculated value at the time of the recording and dummy value
- time and date of the recording
is displayed if logger storage is full.
*) CALC-Function: see chapter 7.6, 7.7