Instructions
H82.0.03.6C-08 Operating Manual GMH 5155 page 7 of 22
_____________________________________________________ _____________________________________________________________________________
5 Start Operation
Connect sensors, turn device on via key.
After segment test the device displays some configuration:
if standard measurement is selected
if fast measurement is selected
if peak value detection is selected
After that the device is ready for measuring.
6 Configuration
Some menu points depend on current device settings (e.g. some points are locked if logger
memory contains data sets).
To change device settings, press “menu” for 2 seconds. This will activate the configuration menu (main
display: “menu” changes between the menus points, pressing jumps to the
referring parameters, which can be selected with key .
The parameters can be changed with or .
Pressing “menu” again jumps back to the main configuration menu and saves the settings.
“enter” finishes the configuration and returns to standard measuring operation.
to factory defaults.
8 Data Logger
If no key is pressed for more than 2 minutes the configuration will be aborted. All changes will
not be saved!
Menu
Parameter
Value
Description
or
Set Configuration: General configurations
Unit: Select measuring unit
*,**
Arrow to bar,
mbar …
Measuring value is displayed in corresponding unit, the selectable
units depend on connected sensor
Arrow to “user”
Measuring value is displayed in freely adjustable user-unit
bar, mbar
0000, 000.0,
… .0000“
-unit selected)
-19999...19999
Sea Level: Sea-level correction
*,**
oFF
Sea-level correction off
on
Sea-level correction on (p.r.t. 7.4)
-2000 ... 9999
Sea-level in [m] (only available by Sensor1 SL = on)
*,**