User manual

E40.0.01.6C-02 Operating Manual EASY LOG 80 CL Page 6 of 12
7.2 Operating possibilities at the device - logger operation
Function Procedure
Display and adjust
cycle time
Push button and at the same time.
The main display shows “CYCL”. The secondary display
shows the currently adjusted cycle time [in sec.].
If the logger is currently not recording, the desired cycle time
[4 sec to 5h (18000 sec)] can be adjusted via the buttons
and .
Press button again to confirm your adjustments and to
leave the menu.
Note: If no key is pressed for more than 2 min, the menu is
quit without saving.
Start recording
Push button for about 5 seconds.
The main display shows “run”.
The secondary display shows “no”.
To start recording select “YES” with the arrow keys
(button or ) and verify with .
Note: If no key is pressed for more than 2 min, the menu is
quit without saving.
Stop recording
Push button for about 5 seconds.
The main display shows “HoLd”.
The secondary display shows “no”.
To stop recording select “YES” with the arrow key
(button or ) and verify with .
Note:
If no key is pressed for more than 2 min, the menu is
quit without saving.
Notice:
If you have activated one of the following options
• “logger stop via buttons disabled”
• “do not stop active logger”
at the configuration of the logger the menu to
stop the recording cannot be called.
SET
1 2
2 3
SET
1
SET
1
2 3
SET
1
SET
1
2 3
SET
1