User Manual

MAINTENANCE

CHAIN OILER

(See Figure 20)

W A R N I N G

To avoid possible serious injury, stop the motor and remove the battery from the pole saw

before replacing the bar, chain, or performing any maintenance operation.

• Use Premium Bar and Chain Lubricant. It is designed for chains and chain oilers and is

formulated to perform over a wide temperature range with no dilution required.

• Remove the cap and carefully pour approximately 2 oz (57 g) of bar and chain lubricant into

the bar lube re

servoir.

• Re

place the cap and tighten securely.

•

NOTE: Do not use dirty, used, or otherwise contaminated lubricants. Damage may occur to the oil pump, bar,

or chain.

the foam.

Fig. 20

Remove

Cap

Bar Lube Reservoir