User Manual

ADJUSTING TELESCOPING POLE (See Figure 6)

• Remove the battery pack from the pole saw.

• Rotate the collar counterclockwise to loosen.

• Push poles towards each other to shorten the pole or pull away from each other to lengthen

the pole.

NOTE: Extend the pole only to the length required to reach the limb being cut. Do not extend the handle

above waist height.

• When the desired length is achieved, rotate the collar clockwise to secure.

NOTE: Adjust hand placement on the shaft of the pole saw to keep proper balance. Do not attempt to use the

pole saw at a length which does not allow you to achieve proper footing and balance at all times.

ASSEMBLING THE POLES (See Figure 6)

• Remove the battery pack from the pole saw.

• Insert handle pole into intermediate pole or powerhead pole rmly.

• Turn the collar clockwise to lock the poles together.

NOTE: Assemble poles only to the length required to reach the limb being cut. Do not extend the handle

above waist height.

NOTE: Adjust hand placement on the shaft of the pole saw to keep proper balance. Do not attempt to use the

pole saw at a length which does not allow you to achieve proper footing and balance at all times.

Fig. 6

OPERATING YOUR POLE SAW

Collar