Operation Manual

18
English
EN
FR DE ES IT PT NL SV DA NO FI HU CS RU RO PL SL HR ET LT LV SK BG
Ŷ Remove the spool from the cutting head.
NOTE: Remove any old cutting line remaining on the
spool.
Ŷ Cut a piece of cutting line approximately 3m long.
Ŷ Insert the cutting line into the anchor hole in the upper
part of the spool. Wind the cutting line around the upper
part of the spool clockwise, as shown by the arrows on
the spool. Place cutting line in the slot on upper spool
flange, leaving about 15cm. extended beyond the slot.
Do not overfill. After winding the cutting line, there
should be at least 0.635 cm between the wound
Ŷ Replace the spool, and the spool cover. Refer to spool
replacement earlier in this manual.
STORING THE TRIMMER
Ŷ Remove the battery pack from the trimmer before
storing.
Ŷ Clean all foreign material from the trimmer.
Ŷ Store it in a place that is inaccessible to children.
Ŷ Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Ŷ Store and charge your batteries in a cool area.
Temperatures above or below normal room
temperature will shorten battery pack life.
Ŷ Never store batteries in a discharged condition. Wait
for battery pack to cool and fully charge immediately.
Ŷ Store the battery pack where the temperature is below
Û&DQGDZD\IURPPRLVWXUH
Ŷ All batteries gradually lose their charge. The higher the
temperature, the quicker they lose their charge. If you
store your unit for long periods of time without using
it, recharge the batteries every month or two. This
practice will prolong battery pack life.
TROUBLESHOOTING
Problem Possible cause Solution
String will not advance when using the
auto-feed head.
String is welded to itself. Lubricate with silicone spray.
Not enough string on spool.
Install more string. Refer to string
replacement earlier in this manual.
String is worn too short. Pull string while pressing line release button.
String is tangled on spool.
Remove string from spool and rewind. Refer
to string replacement earlier in this manual.
Grass wraps around shaft housing and
string head.
Cutting tall grass at ground level.
Cut tall grass from the top down to prevent
wrapping.
Motor fails to start when switch trigger is
depressed.
Battery is not secure.
To secure the battery pack, make sure the
latch on bottom of the battery pack snaps
into place.
Battery is not charged.
Charge the battery pack according to the
instructions included with your model.
Shaft not connected completely.
Make sure lower shaft is fully seated in shaft
coupler on upper shaft and secure shaft
coupler.
cutting line and the outside edge of the spool.