Operating Guide

BATTERY & CHARGER MAINTENANCE

WARNING

If the battery is inserted into the charger when warm or hot, the CHARGING LED indicator light on

the charger may switch on and illuminate ORANGE. If this occurs allow the battery to cool outside

of the charger from approximately 30 minutes.

CHARGER MAINTENANCE

• Keep the charger clean and clear of debris. Do not allow foreign material into the recessed

cavity or on the contacts. Wipe with a dry cloth. Do not use solvents, water, or place in wet

conditions.

• Always unplug the charger when there is no battery pack in it.

• The battery pack may be stored in the charger. however, it is recommended to disconnect the

charger from the power source. To ensure safety and reliability all repairs should be performed

by a qualied service technician.

• Check that the charger contacts have not been shorted by debris or foreign material.

• If the surrounding air temperature is not normal room temperature, move the charger and

battery pack to a location where the temperature is between 65 and 75˚F (18 and 24˚C).

CHARGER MOUNTING (See Figure 10.)

1. This charger can be installed hanging on a wall using two screws (not supplied)

2. Locate the placement for the charger to be wall mounted.

3. If fastening to wood studs use 2 wood screws.

4. Drill two holes on center 4.5 in. apart ensuring that they are vertically aligned.

5. If fastening to drywall use wall anchors and screws to secure the charger to the wall.

Fig.10