User's Manual

Installation and Setup
Before you install your Connected Lighting, make sure that your home network router is operating and
connected to the internet.
Installation Tips
Review the safety information. Be sure to review the information contained in the Safety Information
chapter.
Keep radio signals clear. Your Lighting Gateway and network lighting have antennas built-in for radio
communication with Internet services and other devices on your energy management system. Just as you
might experience reception problems on your mobile phone inside a building, your Lighting Gateway can
have trouble communicating with the network lighting if their radio signals are blocked by obstacles such
as large metal panels or walls containing wire mesh. When placing these devices in your home, imagine
invisible lines connecting between them. Try to keep these lines clear from obstruction as much as
possible. Also place your Lighting Gateway at least 5 feet (1.5 meters) above floor level to promote
reception.
Several factors could affect radio signal strength between a network light bulb and the Lighting Gateway:
•
If the Lighting Gateway is too close to a wireless router, the radio signals from the router could
interfere with the signals the Gateway is processing from the network light bulb. However, the
network light bulb itself does not typically have problems when used close to wireless routers.
•
If the Lighting Gateway is behind a metal object, the radio signals could be blocked.
•
If a network light bulb is placed a significant distance or through several walls from the Lighting
Gateway or other network light bulb, the radio signals could lose strength.
•
If the non-visible construction of a wall contains such things as large metal panels or wire mesh,
the walls could block the radio signal between the network lighting and Lighting Gateway. This
may apply to an entire wall or only specific areas of a wall.
Install Lighting Kit
You will walk through the following steps to install your lighting kit:
•
Step 1: Reset Existing Network Light Bulbs Option
•
Step 2: Install the Lighting Gateway
•
Step 3: Download and Install the Smart Device Application
•
Step 4: Set up Lighting Gateway
•
Step 5: Set up Account
•
Step 6: Install Light Bulb on Network
Product Specifications
Connected Lighting User Guide | 7