User's Manual

Network indicator—solid white for 5 seconds: Lighting Gateway has successfully
connected to your Wi-Fi network.
Network indicator—solid red for 5 seconds: Lighting Gateway failed to connected to
your Wi-Fi network. If no network is found for two consectutive minutes, the process
times out.
Network indicator—red: Lighting Gateway is not connected to the Internet. If your
network indicator is also red, then the problem may be with the Gateway’s connection to
your network router or modem (refer to the network indicator information above).
Otherwise, check that your network router or modem has an active Internet connection.
Bulb indicator—off (no color): Light bulbs are connected to your home network.
Bulb indicator—flashing white: Light bulbs are searching a connection to your home
network.
Indicators —flashing white in sync: Lighting Gateway software is updating. The
indicators flash white in order. commissioning mode to connect with network light bulbs.
The commissioning process continues until all light bulbs and devices searching for the
network have been found. If no devices are found for two consecutive mintues, the
commissioning process will time out.
Indicators —flashing white for 5 seconds in sync: The lighting kit was successfully
reset to the factory settings.
Remote Control
1. 1-4 button: selects all lighting groups to turn on, turn off, dim, or brighten.
2. Group number button: selects the specific lighting group to turn on, turn off, dim, or brighten
as well as programs the lights in the corresponding group. An indicator light above each
number indicates the group number currently being used.
Product Specifications
Connected Lighting User Guide | 4