User's Manual

16. If the Lighting Gateway is not found, scan for Wi-Fi networks on your smart device, as you
normally would.
In the list of networks that display, select the Lighting Gateway.
Enter the password to connect.
Step 5: Set up Account
You must first set up an online account to access your lighting kit remotely. You must remain
connected locally to your lighting network when you create your account.
To set up your account:
17. Tap the Settings menu at the bottom of the page. The Settings page opens.
18. Tap Setup Remote Access. The Account Setup page opens.
19. In the Username field, enter your email address, then tap OK.
20. Enter your password, then tap OK. A message opens when your account is created
successfully.
21. Tap OK to close the message. If an error should occur, a message opens to guide you
through correcting the issue.
When your account is created, we automatically send you an email to confirm your new
account and email address.
22. Follow the instructions in the confirmation email for your account to be activated.
Step 6: Install Light Bulbs on Network
The light bulbs in your lighting kit already come pre-connected to the Lighting Gateway; however, you
must still install the light bulbs. This allows the Lighting Gateway to locate them on the network.
Before installing the light bulbs, determine the appropriate locations in your home for installing them.
Perform the following steps:
23. Turn power OFF to the light fixtures where you are installing the network light bulbs.
24. Remove any existing standard light bulbs from the light fixtures.
25. Install each network light bulb into the light fixtures as you would any standard light bulb.
26. Turn power on to the light fixtures.
If you are installing only light bulbs that came with your kit, you can skip this step. However, if
you are also installing light bulbs that did not come with your kit, then you must connect them
to your Lighting Gateway:
•
When you turn power on, the light bulbs brighten and dim while attempting to connect wirelessly
to your Lighting Gateway.
•
When the light bulbs connected to your Lighting Gateway, they turn on to full brightness.
Product Specifications
Connected Lighting User Guide | 10