User's Manual

•
Step 7: Set up Light Bulbs in Application
•
Step 8: Set up Remote Control Option
Step 1: Reset Existing Network Light Bulbs Option
If you are resetting existing network light bulbs to work with your new lighting kit, you must follow the
following steps. If not, you can skip this step.
Use your original remote control that was supplied with your existing light bulbs. If the original remote
is not available, refer to the Remote Control chapter for additional details.
Perform these steps:
1. Make sure power to the fixtures containing the light bulbs you want to reset is turned ON.
2. Remove the battery cover from the back of the original remote control. This allows access to
the Program button.
3. On the remote control, press and hold the Program button while completing the following
steps.
a. Press and release the On/Off button.
b. Press and release the 1-4 button.
c. Press and release the On/Off button again.
4. Release the Program button.
All group number indicator lights and primary indicator light flash slowly for 30 seconds.
When the light bulbs are removed, they brighten and dim at which time you can add them to
your new network.
Step 2: Install the Lighting Gateway
Since the Lighting Gateway connects to your home network router, make sure you have space near
your router where you can plug in the Lighting Gateway.
Perform the following steps:
5. Make sure your router is already connected to your home network.
6. Power the Lighting Gateway by plugging it into an electrical wall outlet or power strip.
Product Specifications
Connected Lighting User Guide | 8