User's Manual

5
3. Attach Sensor to Meter
Before removing the adhesive backing from the cable sensor, make sure it aligns correctly over the open area of
the template. The grey-colored sensor attaches to your gas meter, and the white-colored sensor attaches to your
electric meter. As you align the sensor over the template, make sure there will be no overhang of the sensor that
might extend far over the template area.
If necessary, the edges of the sensor are perforated to allow you to break it to make the
surface area smaller.
When you are sure of the placement and fit of the cable sensor, remove its adhesive backing and stick the
sensor to the open area of the template. The sensor should stick directly to the meter and not to the template
edges. When the sensor is securely attached to the meter, you can remove the template edges by peeling them
off of the meter.
4. Install Batteries
Your Pulse Reader comes with four AA lithium (FR6) batteries. If these batteries are not already pre-installed,
then remove the cover from the battery compartment on the back of the Pulse Reader unit, insert the batteries as
indicated on the markings in the battery compartment, and then replace the cover.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF
USED BATTERIES ACCORDING TO THE INSTRUCTIONS.