User's Manual

8
Installation
Installation of your lighting kit includes installing the light bulbs into light fixtures and preparing the remote control.
Installation Steps
Before installing the light bulbs, determine the appropriate locations in your home for installing them. The
Lighting Kit Overview chapter provides information on planning your lighting network. When you are ready to
install the light bulbs, perform the following steps:
1. Turn power OFF to the light fixtures where you will be installing the network light bulbs.
2. Remove any existing light bulbs from the light fixtures.
3. Install each network light bulb into the light fixtures as you would any standard light bulb. When
removing each light bulb from the package, note the pre-assigned lighting group number on the
package and install the bulbs in the light fixtures based on your lighting group plan.
4. Turn power on to the light fixtures. The light bulbs turn on to full brightness. If a light fixture has a
dimmer control (not recommended), set the dimmer level to full brightness.