User's Manual

65
b. While pressing the Program button, press the 1-4 button three times.
c. Release the Program button. The primary indicator light starts flashing rapidly.
Once the data transfer process begins between the remote controls, the primary indicator light on the
original remote control starts flashing rapidly.
3. When the new remote control has finished obtaining the network information, the primary indicator lights
on both remote controls light solid for five seconds and then turn off.
4. You can now use the new remote control the same as you do your original. All of the lighting groups
and settings are the same.
If the remote controls’ group number indicator lights flash steadily for two seconds, the cloning process
timed out or failed and you must start over.
Replacing Batteries
Your remote control uses two AA 1.5V alkaline batteries (included). To replace the batteries, remove the battery
cover from the back of the remote control and remove the old batteries. Insert the new batteries as indicated in
the battery compartment.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.