User's Manual

64
Resetting a Light Bulb Manually
If your smart device, Web browser, or remote control are not available you can remove a light bulb from the
network by turning power to the light fixture off and on three times consecutively to reset the light bulb. During
this process, leave the power off for at least two seconds and then on for one to two seconds (after the third
cycle, leave the power on). When the light bulb has been removed from the network, it will brighten and dim
continually.
Cloning a Remote Control
If you have an additional remote control, you can program it to be identical to your original remote control. This is
useful if you think you may need to replace your original remote control or if you simply want to have a backup.
When you clone an additional remote control, it will work the same way as your original remote control.
Before you get started, make sure you have your original remote control in addition to your new one. Both
remote controls must be in range of each other. Remove the battery covers from both remote controls so you
have access to the Program buttons. To clone the new remote control:
1. On the ORIGINAL remote control:
a. Press and hold the Program button.
b. While pressing the Program button, press the On/Off button three times.
c. Release the Program button. The primary indicator light starts flashing steadily.
2. On the NEW remote control:
a. Press and hold the Program button.