User's Manual

them back on after you have finished removing light bulbs). If you do not turn the other light bulbs off,

then they will also be removed from the network since the action applies to the entire lighting group. If

you accidentally remove a light bulb from the network, you can simply add it back again using the

procedure in this chapter for adding light bulbs to the network.

3. On the remote control:

a. Press and hold the Program button.

b. While pressing the Program button, press and release the On/Off button (keep the Program

button pressed).

c. While still pressing the Program button, press and release the Group Number button for the

lighting group assigned to the light bulbs you want to remove; or, if you are removing light

bulbs from ALL lighting groups, press and release the 1-4 button (keep the Program button

pressed, regardless of the group button you press).

d. While still pressing the Program button, press and release the On/Off button again.

e. Release the Program button. The group number indicator light (or all group number indicator

lights if removing all groups) and the primary indicator light flash slowly for 30 seconds while

the light bulbs are removed.

When the light bulbs have been removed from the network, they will brighten and dim.

4. Repeat these steps to remove light bulbs from another lighting group.