User's Manual

43
Removing a Light Bulb Manually
If your smart device, Web browser, or remote control are not available you can remove a light bulb from the
network by turning power to the light fixture off and on three times consecutively to reset the light bulb. During
this process, leave the power off for at least two seconds and then on for one to two seconds (after the third
cycle, leave the power on). When the light bulb has been removed from the network, it will brighten and dim
continually.
Remote Access
After you have created an online account (discussed in the Installation and Setup chapter), you can access your
lighting network remotely. When you start the application, it automatically tries to find a Gateway on any network
to which you may be connected. If the application does not find a Gateway, it opens a login page for you to enter
your user name (email address) and password to access your lighting network remotely. Once you have
successfully logged in, you can manage your lighting network the same way as if you were connected locally.
If your application does find a Gateway, it connects to the lighting network attached to that Gateway. For
example, if you are at a friend’s home and they have a similar lighting kit set up, your application will connect to
their lighting Gateway if you are connected to their local network through their wireless router (which means your
friend would have given you access to log in to their home network). To access your own network remotely, you
would have to log off of the application and then log in again using your online account information. To do so:
1. When you start the application, tap the Settings menu at the bottom of the page.