User Manual

29
is complete, the LED light will remain on for approximately five seconds. When the LED light turns
off, your remote control is ready.
• Replace a lost or broken remote control. If you have an additional remote control that was
previously programmed to be identical to the your original remote control (cloning your original
remote control, as discussed in the Remote Control chapter), then you can use that clone the same
way as your original without losing any of your network or light settings. However, if you do not
have an additional identical remote control, then there is no way to retrieve your settings from the
lost or broken remote control. The only option in this case is to reset your entire lighting system, as
discussed earlier in this chapter.
Replacing a Gateway
{Add content.}