User Manual

28
1. Have your remote control available, and be prepared to perform the light bulb installation steps in the
Installation chapter. If you are replacing a lost or broken remote control, be sure to first prepare the new
remote control, as discussed in the Installation chapter.
2. Turn on and off the light bulb’s fixture three times consecutively. Allow an on time of less than two
seconds each time.
3. Turn the light bulb’s fixture on a fourth time, keeping it on this time. The light bulb begins to brighten and
dim while finding the remote control’s network.
4. At this point you can continue the light bulb installation instructions in the Installation chapter to add the
light bulb to the network.
Problems with Remote Control
Depending on the problem you are having with the remote control, there are several possible solutions:
• Replace batteries. If the remote control is not functioning and the LEDs do not light when you
press the buttons, then the batteries may need replacement. Refer to the Remote Control chapter
for instructions on inserting batteries into the remote control.
• Turn power to fixture on. If you manually turn the power switch off for a fixture, then power will
not be available to the light bulb when you use the remote control to turn the light on and off. Be
sure the appropriate fixtures are left in the on position. If necessary, refer to the Power Failure
section in this chapter.
• Reinitialize the remote control. If the remote control is not functioning correctly but the batteries
are new, then you may have to reinitialize the remote control. To do so, press the {???PRG???}
button for three seconds. The primary LED light will flash while it is reinitializing. When this process