User Manual

20
Cloning a Remote Control
If you have an additional remote control, you can program it to be identical to your original remote control instead
of using it as an additional remote control on the network. This is useful if you think you may need to replace your
original remote control or if you simply want to have a backup. When you clone an additional remote control, you
cannot use it to control new lighting groups. It will work the same way as your original remote control.
Before you get started, make sure you have your original remote control in addition to your new one. Both
remote controls must be in range of one another. To clone the new remote control:
1. On the ORIGINAL remote control, press the {???PRG-ON???} button. The primary LED light will start
flashing.
2. On the NEW remote control, press the {???PRG-ALL-OFF???} button while the LED light on the
original remote control is still flashing. The primary LED light on the new remote control will also start
flashing while it obtains the network information from the original remote control.
3. When the new remote control has finished obtaining the network information, the LED on the new
remote control lights steady for approximately one second and then turns off. The LED light on the
original remote control also turns off automatically when the process is complete.
4. You can now use the new remote control the same as you do your original. All of the lighting groups
and settings are the same.
Installing Batteries