User Manual

19
Adding Additional Remote Controls to the Network
You may want to add additional remote controls to your network either to have more lighting groups (each
remote control can have four separate groups) or for convenience so that you can have multiple remote controls
to leave in different rooms.
Before you get started, make sure you have your original remote control in addition to your new one. Both
remote controls must be in range of one another. To add the new remote control to the network:
1. On the ORIGINAL remote control, press the {???PRG-ON???} button. The primary LED light will start
flashing.
2. On the NEW remote control, press the {???PRG-ALL-ON???} button while the LED light on the original
remote control is still flashing. The primary LED light on the new remote control will also start flashing
while it obtains the network information.
3. When the new remote control has finished obtaining the network information, the LED on the new
remote control lights steady for approximately two seconds and then turns off. The LED light on the
original remote control also turns off automatically when the process is complete.
4. You can now use the new remote control on your network (refer to all of the same procedures in this
chapter to operate the new remote control). The four group buttons on the new remote control represent
four new lighting groups that are now available on your network, and you can now program your light
bulbs for the groups (each light bulb can belong to a maximum of eight groups).