User Manual

18
control will remain in this mode and flash for approximately five minutes to give you time to install any
additional light bulbs). When the light bulb has been added to the network, it will turn on at full
brightness.
6. Add the new light bulb to a lighting group by pressing the numbered button for the group on the remote
control. The light bulb dims and then returns to full brightness to indicate that it has been added to the
group. To add the light bulb to more than one group, you must first finish this installation. When the
installation is complete, refer to the section Adding a Light Bulb to a Group in this chapter to add the
light bulb to more lighting groups.
7. Leave the fixture switch ON so that power is available when using your remote control to turn the light
bulb on and off.
8. To add more light bulbs, repeat steps 1 – 7. Remember, if the primary LED light on the remote control is
still flashing from step 4, then it will automatically find the new light bulb without you pressing any
buttons. However, if the LED light has stopped flashing, press the {???PRG-ON???} button again so it
can find the new light bulb. Repeat this for each additional light bulb you are adding.
9. When you are finished adding all new light bulbs, you can turn the remote control back to normal
operation by pressing the {???PRG-OFF???} button. Otherwise the remote control will automatically
return to normal operation in five minutes. The primary LED light on the remote control turns off when
returned to normal operation.