User Manual

17
range of the remote control, you must manually turn that light off or remove the light bulb from its fixture
so that no power is being supplied to the light bulb.
2. Make sure your remote control is in range of all light bulbs you are removing.
3. On the remote control, press the following buttons in sequence:
a. {???PRG???} button
b. The numbered button for the lighting group your are adding the light bulb to
c. {???OFF???} button
The light bulb(s) dim and then return to full brightness to indicate that they have been removed from the
group.
Adding Additional Light Bulbs to the Network
Your remote control can manage up to 40 light bulbs on the same lighting network. To add each additional light
bulb to the network:
1. Make sure your remote control is in range of the light bulb you are adding.
2. Make sure power to the fixture where you are installing the light bulb is turned OFF.
3. Install the light bulb into the fixture.
4. Turn power to the fixture on. The light bulb begins to brighten and dim while finding the remote control’s
network.
5. While the light bulb is brightening and dimming, press the {???PRG-ON???} button on the remote
control. The primary LED light will flash while the light bulb is being added to the network (the remote